This is for one gear selector bezel. 
Construction: High temp resistant photopolymer resin part finished in urethane 2k base coat clear coat paint. 
 
Installation: Pre installed 3m vhb double backed tape. Will install strips on the inside. Install by cleaning the factory knob with alcohol. Pull strips and install over the factory knob. There are slots on the bottom side you will need to line up to get it to drop into place. This material is reactive to hot and cold so please install at room temperature or slightly higher. It may be difficult to line up the slots otherwise. The slots are there to reduce pressure on the 3m tape when twisting the knob into and out of gear. 
Return policy: full refund if returned within 30 days of receiving the items for any reason.
Please allow 3-4 weeks for shipping,thanks!